Drainage Rods 12 Pc 9 Metre Drain Rods Set 66108C

A competitively priced drain rod set for the home or workshop

Description:
 
• 10 x 3 feet (920mm) drain rods with the following screw in heads:
• Plunger head 100mm: Can be used to unblock drains using a back and forward pumping motion
• Worm 50mm double worm screw head: For use on rags and paper that may be clogging the drain
• The rods have simple screw in easy join zinc ends

How to use

assemble two or three rods along with the 4" rubber disk. Insert slowly into the drain so that the rubber disk penetrates two or three feet - this will need you to add lengths of drain rod.

This should be inserted in the direction of the property, if you are on mains drainage, then most likely away from the street. If the access point is backed up, then you should clear towards the street.

You might have to feel - or probe - for the drain hole when inserting the rods as it might be obscured with effluent.

Take care when adding or removing drain rods that the rod that is within the drain is NEVER rotated counter clockwise. This might result in the unscrewing of the rods or the rubber disk - that will totally block the drains, possibly resulting in very expensive remedial action!

With the rubber disk and rods in the drain, very quickly pull the rods out - this is often sufficient to start the drains flowing.

If the drains do not flow, try again but with more lengths of rod inserted. From here on in the best advice is 'suck it and see' though not literaly.
 

 For all other postage zones please go Here to purchase your zone postage